HOMEMADE GIMBAL BEARING DRIVER DOWNLOAD

April 5, 2019 posted by

Jeff, I have access to a huge selection of drivers. Register Now In order to be able to post messages on the Speedwake 2. Took like 10 minutes and was a cinch, no pounding or pulling required. I bent several steel plates with my homemade device and couldnt get it. I have the alignment tool but not the bearing driver. Upload Photos or Videos. Don’t have anything better to do so I looked it up:

Uploader: Gukazahn
Date Added: 21 June 2016
File Size: 20.93 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 14172
Price: Free* [*Free Regsitration Required]

I bent several steel plates with my homemade device and couldnt get it.

It has a few rough spots and the drive is off so I deceided I better replace it. Thanks for beearing tip on re-installing with the notches out!!!

Contact Us Advertise Speedwake 2. I tried this 6 times and got the same result. Mine was out after 5 or 6 good whacks It is a heavy puller, with an 8 lb. I then used a 3 clawed slide hammer and pulled the outer aluminum ring off.

Homemade Gimbal Bearing Puller

But I got it. Bt Doctur That tool looks awesome you could sell those.

I am building a puller. First, its really really hard to keep it flat on the bearing, while holding a 2×4 bearint the other end, and hitting it with a small sledge. If you are real lucky the housing is already installed with the notches facing out and all you would need to do is replace the cartridge bearing.

Related Drivers  ALADDIN TNT2 DRIVER DOWNLOAD

Announcement

Will this work to pull against the seal and then the bearing? I could probably take the bearing out of the housing, drive the housing gimbla with a large socket that fits the outer edge of the housing, then re-install the bearing. I made one from an aluminum plate and a “T” welded to a length of chain and astud welded to free end.

This ia a good site for looking up part numbers: Quick Reply Share with Facebook. September 19th, They came right out. It was at mercstuff.

Gimbal Bearing Replacemnet – Method B

Took like 10 minutes and was a cinch, no pounding or pulling required. Have a marina do the job, they can be a real b1tch!! Next, make sure you install the housing with the two notches facing out so you can easily replace the bearing in the future using above method of cartridge removal from housing.

For some unknown reason merc installed these with the notches facing in to make things hard. I am replacing the bellows and the gimbal bearing.

Related Drivers  MS9590 DRIVER DOWNLOAD

Also I found a website that had pics. August 13th, Alot of good Ideas I’m going to replace the gimbal bearing at the end of the season. September 17th, I went the 3″ pvc route.

Options Quote message in reply?

Scott, Thanks, I have done about a gazillion of them, just wanted to know if you needed the tool to get it back in there. Don’t have anything better to do so I looked bearinv up: Scott, How are you going to install it? I was told by local marina mechanic that he could never get one out with a slide hammer either. Check your serial and it will tell you which one you have.